GodHand Ultimate Nipper 5.0

GodHand Ultimate Nipper is a nipper that specialises in gate cutting in pursuit of the "ultimate cut". Its incredibly thin and sharp blade makes it possible to achieve a smooth cut surface with minimal stress marks on the plastic. It also cuts much closer to the surface, reducing the time needed to remove nubs using a file or cutting knife.

A cap is included for the head to protect the nipper from damage while in storage.

• Single-edged type nipper
• The cutting blade is created by the craftsmen of "Tsubamesanjo" in Niigata prefecture, famous for cutting tools
• Blade breakage prevention stopper
• Over-opening prevention pin
• Soft grip
• Original nipper cap included

Important Note

This is a precision nipper with a delicate blade. If used improperly, the blade may chip or break. Please follow the guideline below when using this nipper.

• Use only for cutting plastics with a maximum diameter of 3mm (or 1mm for transparent/semi-transparent plastics)
• Never cut pieces that exceed the cutting capacity above or non-plastic materials (metal, resin, paper, etc ...)
• Note the limit above refers to the diameter, not just thickness
• Do not squeeze with more force than necessary as it can cut even with nominal force
• The blade gets thinner and more delicate towards the tip, so cut as close to the centre of the blade as possible
• Do not twist the blade during cutting or when removing the blade from the runner after cutting. Doing so causes a rotating force to apply to the blade and can cause it to break
• Remove any nubs stuck on the blade using a soft brush before the next cut as they may cause extra stress to the blade
• Do not touch the cutting edge of the nipper directly by hand as oil from your finger causes rust
• Store in a dry location as moisture can cause rust, degrading the performance of the blade